Call(239) 330-9836

Home / Services / Static pressure

High static pressure, explained.

Static pressure is how hard the blower has to push to move air through the filter, the coil & the ducts. It's measured in inches of water column. Most home systems are built to run around half an inch. Above that, the blower moves less air, works harder & wears out sooner.

What high static pressure does

  • Less air at the vents & warm rooms at the end of the runs.
  • A coil that runs too cold & freezes.
  • A blower motor that runs hot & fails early.
  • Higher bills, because the system runs longer to do the same job.
  • Noise: whistling at the return, air rushing at the registers.

Where it comes from

  • The return side. Too few returns, or one that's too small. More on return air.
  • The filter. Dirty, or a thick high MERV filter in a slot made for a thin one.
  • The coil. Dirt & growth on the coil block air like a second filter.
  • The supply ducts. Crushed flex, tight turns, runs that are too small for the system.
  • A system bigger than the ducts. A new, bigger unit on old ducts pushes against the same wall.

How we read it

A gauge on the system, reading before & after the blower. The number tells us whether the system can breathe, & where the readings change tells us where the problem is: filter, coil, return or supply. Then you get a written price for the fix before anything gets done.

More on air moving

Residential$95$130 after hours
Commercial$125$160 after hours
  • Some of it

    ReturnsA return we added. The system was starving for air & the static pressure said so. The whistling stopped & the coil stopped freezing.
  • DuctworkFifteen year old flex, blown clean off the plenum. The homeowner called about low airflow. The attic had been getting most of the house for a while.

Questions people ask

It depends on the blower; the number is on the unit's data plate & in the manual. Most home systems are built for about half an inch of water column. We read yours & compare it to what your blower is rated for.
Yes. A thick, high MERV filter in a slot made for a 1 inch filter is one of the most common causes. A filter cabinet with more area fixes it without giving up the filtering.
No. If the ducts are the limit, a bigger unit pushes against the same wall & short cycles. Fix the air path first.
The diagnostic is $95 ($130 after hours). The fix can be a filter, a coil cleaning, a new return or duct work, & you get the written price before anything gets done.

Think comfort. Think Aphex.